Remotec ZTS-110 V3.05 Bedienungsanleitung

ZTS-110Z-ThermostatUSER MANUALPrinted in ChinaF820-8031-00032/11/14Firmware Version: 2.0639Revised on 2/13/14Revised on 2/14/14 V3.05FCC NoticeThis d

Change ModeNote: In Heat mode =>it displays "HEAT" if ELECTH is selected during jumper setting.=> it displays "HEAT PUMP" if

Override/Permanent OverrideNote: Override/Permanent Override is only available in HEAT, COOL or AUTO mode.LCD indicationStep Procedure / DescriptionPr

LCD indicationStep Procedure / DescriptionPress and hold "UP" and "DOWN" key for 2 seconds to disable / enable event during the ti

Battery Low IndicationDefrost IndicationOut of Temperature Range Indication23 24LCD indicationProcedure / DescriptionZTS-110 thermostat will detect th

25 26Filter CounterShort Cycle Start Up ProtectionTo protect the compressor / Heat pump, those outputs forced off until 3minutes count down finished.

Check FLiRS / Always Listening mode in ZTS-110Z-Wave Add (Include) / Delete (Exclude) into/from Z-Wave networkAdd (Include) ZTS-110 to Gateway / Contr

Note:- It is recommended to perform the Delete/Exclude procedure before doing Add/Include. This is to make sure the ZTS-110 is not in any other Z-Wave

31 32Z-Wave Configuration ParametersDifferent user has different preferred settings of their thermostat, you may use the below configuration parameter

Parameter value rangeParameter No.Functions0 (0x00) = disable AUTO report if room temperature is different from last report.AUTO repor

Reset ZTS-110 to Factory Default SettingsLCD indicationStep Procedure / DescriptionPress and hold "Fan" + "Mode" keys for 2 second

Table of ContentsIntroduction 2Features list 3Glossary 4Physical Installation and Wiring 5Installation Location 6 6Wiring 7Jumper Settings for ELEC

37 38Technical SpecificationsModel no.BW8031US (ZTS-110US)BW8031AU (ZTS-110AU)BW8031EU (ZTS-110EU) RF frequency908.4MHz (US) (ZTS-110US)921.4MHz (AU)

Features ListHVAC System Type Compatible: - Standard (gas/electric) or Heat PumpMultistage System Compatible: - Standard HVAC Systems: 2 stage heating

Physical Installation and WiringRead following scenarios carefully before you start as it matters to the battery life under Z-Wave operation:ZTS-110 c

Figure 5. Heat pump HVAC system wiringFigure 6. Non-heat pump 2-wires system wiringFigure 7.Heat pump 2-wires system wiringThermostat should be powere

9 10Jumper Settings for ELECTH-HPUMP and HE-HGThere are 6 jumpered pins on the thermostat circuit board that identify whether your system is:- Gas or

11 12Activate/Deactivate Easy ModeThe ZTS-110 is default with Easy mode, below illustrates the functions of Easy mode:- Active functions: Change Mode,

13 14If you deactivated the Easy mode, you can continue to set up Day, Clock, 12/24 hour, F/C, Swing and Differential. Refer to below for steps:LCD in

15 16Note: Explanations of Swing and Differential set pointHEAT mode: thermostat controls the temperature according to the following diagramo o o Ex