Remotec ZTS-100 V2.04 Bedienungsanleitung PDF herunterladen (Seite 9)

Jumper Settings for ELECTH-HPUMP and HE-HG:

Mounting:

1. Open the ZTS-100 by pushing the hook (Figure 5)

2. Install AAx4pcs batteries if using battery power (Alkaline batteries are

recommended)

3. Check the polarity of the batteries and the "+/-" marks inside the battery

compartment

4. Connect 24Vac power if using 24Vac power source

5. Place the cables at the hole near the terminal block

6. Insert 2 pieces of wall anchors into the holes of the wall

7. Fasten the thermostat with 2 pieces of long screws through the 2 mounting holes

(Figure 6)

8. Install the top housing by hooking the bottom (Figure 6)

Jumper Function Description

Set to ELECTH for non heat pump system (Default)

Set to HPUMP for heat pump system

Set to HG for Gas heat-fan controlled unit (Default)

Set to HE for Electrical heat-fan controlled unit

ELECTH

HPUMP

ELECTH

HPUMP

Figure 6. Install the top housingFigure 5. Open ZTS-100

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Keine Kommentare

Remotec ZTS-100 V2.04 Bedienungsanleitung Seite 9